AL-300A 2-in-1 LED Strobe and Torch
Model：AL-300A
AL-300A is a compact flashing strobe light with a super bright LED torch on the other end.
Use to maintain contact in dark or limited light
convenient & handy sized for carrying
Strobe is visible about 3 kilometers
Attachable Velcro strap included
Use to maintain contact in dark or limited light
convenient & handy sized for carrying
Strobe is visible about 3 kilometers
Attachable Velcro strap included
• Housing: Plastic
• Battery: 3 x Alkaline AA-cell, not included
• Torch bulb: Cree XPE-R2
• Torch burn time: 6+ hours
• Torch Brightness: 130+ lumens
• Strobe bulb: Cree XML2-U4
• Strobe burn time: 72+ hours
• Strobe brightness: 500+ lumens
• Flash Rate: 36~40 times per minute
• Dimensions: 13.7 cm x 5 cm (L x Dia.)
• Waterproof: 60 m
• Battery: 3 x Alkaline AA-cell, not included
• Torch bulb: Cree XPE-R2
• Torch burn time: 6+ hours
• Torch Brightness: 130+ lumens
• Strobe bulb: Cree XML2-U4
• Strobe burn time: 72+ hours
• Strobe brightness: 500+ lumens
• Flash Rate: 36~40 times per minute
• Dimensions: 13.7 cm x 5 cm (L x Dia.)
• Waterproof: 60 m
1. Avoid diving lights/flashlights from heavy objects or heavy drops.
2. It is recommended to confirm the full charge before each use, check if the O-ring is normal and apply oil to slow down the cracking.
3. After each dive, use water (use warm water to increase the salt melting speed) soak (recommended for 3 hours). Dry with a soft cloth, then carefully remove the battery.
4. Do not over-tighten the dive light/flashlight to avoid O-ring abrasion and deformation, resulting in increased water ingress.
5. Please keep it in a cool, dry place to avoid extreme heat, direct sunlight and chemical damage.
2. It is recommended to confirm the full charge before each use, check if the O-ring is normal and apply oil to slow down the cracking.
3. After each dive, use water (use warm water to increase the salt melting speed) soak (recommended for 3 hours). Dry with a soft cloth, then carefully remove the battery.
4. Do not over-tighten the dive light/flashlight to avoid O-ring abrasion and deformation, resulting in increased water ingress.
5. Please keep it in a cool, dry place to avoid extreme heat, direct sunlight and chemical damage.
